Aluminum power transmission busbars

Aluminium busbar for conductive links in electrical panels and equipment. Select according to load current, bar dimensions, contact design and installation conditions.

Range: 4 m aluminium busbars

Aluminium busbar for conductive links in electrical panels and equipment. Select according to load current, bar dimensions, contact design and installation conditions.

Technical data

Product	Cross-section	Weight, kg / 4 m
30 × 5 mm	150 mm²	≈ 1.62
30 × 10 mm	300 mm²	≈ 3.24
60 × 10 mm	600 mm²	≈ 6.48
80 × 10 mm	800 mm²	≈ 8.64
100 × 10 mm	1000 mm²	≈ 10.8
6 × 80 mm · AD31T	480 mm²	≈ 5.2
6 × 60 mm · AD31T	360 mm²	≈ 3.84
6 × 40 mm · AD31T	240 mm²	≈ 2.6
6 × 30 mm · AD31T	180 mm²	≈ 2
5 × 60 mm · AD31T	300 mm²	≈ 3.3
5 × 50 mm · AD31T	250 mm²	≈ 2.72
5 × 40 mm · AD31T	200 mm²	≈ 2.2
4 × 40 mm · AD31T	160 mm²	≈ 1.8
3 × 30 mm · AD31T	90 mm²	≈ 1
3 × 20 mm · AD31T	60 mm²	≈ 0.7
3 × 15 mm · AD31T	45 mm²	≈ 0.5

Weight is approximate, based on catalogue data. Linear weight is given per metre; the product price is for one 4 m bar.

Application and installation

For electrical distribution and control panels and equipment connections. Use as an N or PE bar requires a design selected and verified by the designer.

Current capacity depends on temperature, cooling, bar arrangement and connections. Cross-section alone does not determine current capacity; check manufacturer documentation and the panel design.

Prepare and tighten aluminium contacts according to the connection manufacturer’s instructions. Use a compatible connection system for Cu–Al joints; contact paste alone does not replace proper connection selection.

A bare busbar is not insulated. Suitable supports, insulation clearances and protection against contact are required. Check short-circuit withstand.