Products catalog

  • Niestety, nie można znaleźć przedmiotu, którego szukasz. Inne towary w tej kategorii przedstawiono poniżej.

    Gel junction box | 3 × 4 mm² | Ø 10–16 mm | 125 × 43 × 35 mm | IP68 / IP69 | Raytech DINO | DINO

    Code: DINO

    Raytech DINO is a gel-filled junction box with 2 sealed entries and terminals: 3 × 4 mm². Cable diameter Ø 10–16 mm, protection IP68 / IP69, dimensions 125 × 43 × 35 mm.

  • Gel junction box | 3 × 4 mm² | Ø 10–16 mm | 125 × 43 × 35 mm | IP68 / IP69 | Raytech DINO | DINO

    Raytech DINO is a gel-filled junction box with 2 sealed entries and terminals: 3 × 4 mm². Cable diameter Ø 10–16 mm, protection IP68 / IP69, dimensions 125 × 43 × 35 mm.

    Key idea:
    Instead of an ordinary box with glands and sealant, this is a ready box in which the gel already seals the entries and terminals. It suits places where the connection will be outdoors, damp or flooded – for example in lighting, CCTV or automation installations.
    Sealing
    IP68 / IP69
    Terminals
    3 × 4 mm²
    Cable Ø
    Ø 10–16 mm
    Entries
    2

    How it works

    The cables are fed through the integrated sealed entries and the cores are connected to the terminals inside the box.

    The box is closed by snapping the lid shut (no screws). The gel surrounds the terminals and entries, so water and moisture cannot reach the connection.

    The box can be mounted on a wall or ceiling indoors and outdoors and can be opened later to change the connections.

    Why choose DINO?
    One product instead of a box, glands, sealant and insulation – less work and fewer installation mistakes.

    Technical specifications

    Product typePre-filled gel junction box with sealed entries
    Manufacturer / seriesRaytech (Italy)
    ModelDINO
    CodeDINO
    Wires (number × cross-section)3 × 4 mm²
    Cable outer diameterØ 10–16 mm
    Number of entries2
    KitIntegrated terminals and sealed cable entries
    Dimensions (L × W × H)125 × 43 × 35 mm
    Degree of protectionIP68 / IP69
    Operating temperature+90 °C (max.)
    Installation temperature−40…+50 °C
    FillingHalogen-free polymer gel (UL 94-HB), not classified as hazardous (CLP)
    InstallationIndoor, outdoor, underground, submerged
    Re-enterableYes
    Shelf lifeUnlimited

    Main features

    • Integrated sealed entries – the cable is retained and sealed.
    • Terminals included – ready to install.
    • IP68 / IP69 sealing – suitable for flooded locations.
    • Snap-on lid – no screws needed.
    • Re-enterable – connections can be reworked.
    • UV resistant, halogen-free – for outdoor and public areas.

    Where is it used?

    • Power supply for CCTV cameras
    • Facade, path and stair lighting
    • Garden and pool luminaires
    • Gates and automation equipment
    • Damp rooms, basements, garages
    • Industrial and construction sites

    Use by need

    For the security systems installer.
    A neat, sealed camera or device power connection outdoors.
    For the lighting installer.
    Branches to several luminaires in one compact box.
    For the electrician.
    A ready solution for damp locations without sealant or extra glands.

    Practical example

    If an outdoor luminaire or camera on a facade has to be connected to the supply cable, the cables are fed into the DINO entries, connected to the terminals and the lid is snapped shut. The connection is protected from rain and moisture without extra sealing.

    Pros

    • Ready to use – with terminals and entries
    • IP68 / IP69 sealing
    • Screwless installation
    • Re-enterable
    • UV resistant, halogen-free

    Cons / limitations

    • Cable diameter must be within the entry range
    • Terminal cross-section is limited – for larger cables choose a joint
    • Damaged gel cannot be restored – the box must be replaced

    Safety and installation notes

    • Work with the supply switched off.
    • Insert the cable only as far as the manufacturer specifies – otherwise sealing will suffer.
    • Tighten terminals properly and leave no bare conductors.
    • Snap the lid fully shut.
    • Do not mount the box where it may be mechanically damaged.

    Quick selection guide

    3 × 4 mm²
    Ø 10–16 mm
    125 × 43 × 35 mm
    IP68 / IP69
    Raytech DINO
    DINO
    Suitable when you need:
    • A sealed wall or ceiling connection outdoors
    • Branches to luminaires or cameras
    • Installation without sealant or glands
    Check before use:
    • Cable outer diameter
    • Number of cores and cross-section
    • Number of entries required
    Important reminder: The box does not replace line protection – the circuit must be protected by a circuit breaker and, outdoors, by an RCD.

    FAQ

    Are terminals included?
    Yes, terminals are included.
    Can it be installed outdoors?
    Yes, the box is UV and moisture resistant.
    Is sealant needed?
    No, the entries and terminals are sealed by the gel.
    For what cable diameter?
    Ø 10–16 mm.
    Can it be opened?
    Yes, the box is re-enterable.
    Can it be wall-mounted?
    Yes, on a wall or ceiling.

    Gel junction box | 3 × 4 mm² | Ø 10–16 mm | 125 × 43 × 35 mm | IP68 / IP69 | Raytech DINO | DINO

    Gel junction box | 3 × 4 mm² | Ø 10–16 mm | 125 × 43 × 35 mm | IP68 / IP69 | Raytech DINO | DINO – a sealed, quick-to-install solution for electrical connections outdoors, underground and in damp locations. Available at elsprendimai.eu – ELSprendimai has checked the technical data and will help you choose the right size.

    Published: 2026-11-18 · Data checked against manufacturer and supplier data: 2026-11-18

    Illustrative image may have been created using AI. The appearance of the product may differ slightly from the image shown. Please refer to the technical specification.
  • Alternative products

    Insulated twin bootlace ferrule | 2×16mm² | 14mm | crimp | blue | 100 pcs | Sofamel APF/D-16,00D | 255180
    Code: 255180

    Insulated twin wire end ferrule 2 × 16 mm² for flexible wires, 14 mm tube, blue. Sofamel APF/D-16,00D, tin-plated copper, PA collar. 100 pcs per pack.

    Price 14.40 € VAT incl.
    ( 11.90 € VAT excl. )
    Terminal block | electrical wire connector | spring-loaded | lever-operated | 5x0.08-2.5mm² | max. 4mm² | WAGO | 222-415 | 4044918464956
    Code: 4044918464956

    Installation spring terminal connector with foldable levers, designed for fast, reliable and tidy electrical wire connection without screws or additional tools. This terminal block is especially useful when performing electrical installation, lighting, junction box, automation or renovation work, where wires need to be quickly connected, disconnected or inspected. 

    Price 0.52 € VAT incl.
    ( 0.43 € VAT excl. )
    Cable gland with locknut and gasket | PG7 | for cable Ø3–6.5 mm | grey | IP68 | 4772124000810
    Code: 00810

    Plastic PG7 cable gland with locknut and gasket for routing Ø3–6.5 mm round cables into distribution boards and junction boxes. Provides IP68 sealing when correctly installed.

    Price 0.20 € VAT incl.
    ( 0.17 € VAT excl. )
  • Subscribtion to new arrivals

    privacy policy

    Information