Cable ties with marking tag | 2.5x100mm | white | 100 pcs. | IEK | 4606056167535

Cable ties with marking tag | 2.5×100 mm | tag 10×24 mm | white | 100 pcs | IEK | 4606056167535

White cable ties with an integrated marking tag, designed for grouping and identifying wires and cables with a single fastening element. Tie dimensions – 2.5×100 mm, marking tag size – 10×24 mm. The tag can be used for cable, circuit, equipment or other identification information. Pack quantity – 100 pcs.

This cable tie makes it possible to group and identify a wire or cable bundle with one element while keeping the marking area clearly visible. It is practical for switchboard assembly, automation panels and other electrical installations where fast and reliable identification of wires, circuits or connection points is important.

The 10×24 mm tag provides a dedicated area for cable numbers, circuit numbers, equipment references or other technical identification. This simplifies installation, maintenance, troubleshooting and future modifications.

2.5×100 mm refers to the cable tie itself, while 10×24 mm refers to the integrated marking tag. These dimensions should not be confused.

• Grouping wires and cables.
• Integrated 10×24 mm identification area.
• Grouping and marking combined in one element.
• 2.5×100 mm cable tie dimensions.
• White surface provides a contrasting background for marking.
• Suitable for organising wiring in switchboards and automation panels.
• 100-piece pack suitable for repetitive installation work.

• Switchboard assembly.
• Automation and control panels.
• Control circuit wire identification.
• Cable and wire bundle identification.
• Equipment connection wiring.
• Repair and refurbishment work.
• Installations where fast wire identification is important.

1. Select a position where the marking tag will remain clearly visible after installation.
2. Wrap the tie around the wire, cable or cable bundle.
3. Insert the end of the tie into the locking head and tighten evenly.
4. Do not tighten more than necessary to hold the wires securely.
5. Check that the cable insulation is not compressed or deformed.
6. Mark the tag according to the identification system used in the project or installation.
7. If required, cut off excess tie length as close to the locking head as practical, leaving no sharp protruding edge.

The marking method should be selected according to the tag surface and service conditions. If the identification must remain legible for a long time, check the adhesion and durability of the chosen marking method before serial use.

• Tighten only enough to hold the wire or cable bundle securely.
• Avoid compressing or deforming cable insulation.
• Do not use the tie as a structural cable support unless this application is declared.
• After cutting off excess tie length, check that no sharp edge remains.
• The marking must remain visible and legible after installation.
• Coordinate identification with electrical drawings and the cable-numbering system used on site.

IEK | 2.5×100 mm | tag 10×24 mm | 100 pcs

Cable ties with an integrated marking tag for grouping and identifying wires and cables. The 2.5×100 mm tie and 10×24 mm marking area combine grouping and identification in one element for switchboards, automation panels and other electrical installations.