Electric footwear / shoe dryer with timer | 220W | 230V | 100x225x865mm | IP20 | white | ADAX ST3D White

Electric shoe dryer | 4 hoses | for 2 pairs of shoes | 220 W | timer up to 180 min. | white | ADAX ST3D White

ADAX ST3D White – an electric 220 W shoe dryer designed to efficiently dry various types of footwear. Warm air is supplied into the footwear through 4 flexible hoses, allowing up to two pairs of shoes to be dried at the same time.

The flexible hoses allow warm air to be directed deep into the footwear, including its lower part. The integrated timer allows a drying time of up to 180 minutes to be selected, with adjustment in 30-minute increments. The dryer is supplied with a 1.20 m power cable and plug.

ADAX ST3D White is a practical wall-mounted shoe dryer for family or everyday use. Four air channels allow two pairs of footwear to be dried at the same time, the 220 W power provides warm-air circulation, and the timer adjustable up to 180 min. allows the drying time to be adapted to the moisture level of the footwear.

Blown-air temperature: approximately 20 °C above ambient temperature. The dryer also has overheating protection.

Four flexible hoses allow up to two pairs of shoes to be dried at the same time. The hoses can be directed inside the footwear so that warm air reaches the lower part of the shoe. This is especially convenient for drying everyday, work, outdoor, sports or children's footwear.

1. To switch on the ST3D, use the “+” control button.
2. The operating duration is changed in 30-minute increments.
3. The maximum selectable operating time is 180 minutes.
4. The selected drying time is shown on the device display.
5. When the set time expires, the drying cycle ends.

The dryer has overheating protection, which provides an additional safety measure during operation. The air inlet and outlet areas must remain unobstructed so that air can circulate freely.

• Entrance hall.
• Corridor.
• Utility room.
• On a balcony, if the environmental conditions comply with the usage requirements of an IP20 device.
• Detached house or apartment.
• For drying work, leisure, sports and everyday footwear.

• The dryer is intended for installation in a stable location.
• Install it so that all four hoses can be conveniently connected to the footwear.
• Air inlet and outlet openings must remain unobstructed.
• Keep away from flammable materials.
• Disconnect the appliance from the mains before installation or maintenance.
• The appliance must be installed according to the manufacturer's installation instructions supplied.

• Do not cover the air inlet and outlet openings.
• Do not use the appliance if the power cable or the device itself is damaged.
• Disconnect the power supply before cleaning, maintenance or removal from the installation location.
• Keep the appliance away from flammable materials.
• Use only for its intended purpose – drying footwear.
• The IP20 protection rating means that the appliance must not be placed where it may be exposed to water splashes or precipitation.

ADAX ST3D White | shoe dryer | 220 W | 4 hoses | for 2 pairs | timer up to 180 min.

ADAX ST3D White – a white 220 W electric shoe dryer with four flexible air hoses, allowing up to two pairs of footwear to be dried at the same time. The timer is adjustable up to 180 minutes, while the blown-air temperature is ambient temperature +20 °C. Dimensions 100 × 225 × 865 mm, IP20, overheating protection, 1.20 m cable with plug and a 2-year warranty.