Products catalog

  • Industrial 4G LTE gateway | Cat 4 | 1 × Gigabit Ethernet | I/O | compact | Teltonika TRB140

    Code: TRB140
  • Industrial 4G LTE gateway | Cat 4 | 1 × Gigabit Ethernet | I/O | compact | Teltonika TRB140

    The Teltonika TRB140 is a miniature industrial 4G LTE gateway for connecting a single device to the internet: a controller, PLC, meter or camera. One Gigabit Ethernet port, I/O and low power consumption.

    Key idea:
    When only one device needs connecting, a full router with Wi-Fi is unnecessary. The Teltonika TRB140 fits into a cabinet or device housing, uses only < 5 W and turns a mobile connection into wired Ethernet.
    Cellular
    4G LTE Cat 4, up to 150 Mbps
    SIM
    1 SIM
    Wi-Fi
    —
    Ethernet
    1 × Gigabit, I/O

    Operating principle

    The gateway is fixed in a cabinet or device housing, an LTE antenna is connected via the SMA connector and power is supplied via the 4-pin connector or passive PoE.

    A controller, PLC, camera or other device is connected to the single Gigabit Ethernet port and gets internet over the mobile network. Two configurable I/O let you monitor a signal or control a relay.

    The result is a single device that becomes reachable remotely via VPN or Teltonika RMS, without a separate router and without Wi-Fi.

    Why choose the Teltonika TRB140?
    The smallest solution for a single device: Gigabit Ethernet, I/O and < 5 W consumption. No need for a Wi-Fi router where nobody will use it.

    Technical specifications

    Product type Industrial 4G LTE gateway (no Wi-Fi)
    Manufacturer / model Teltonika TRB140
    Cellular 4G LTE Cat 4 (up to 150 / 50 Mbps), 3G/2G fallback
    SIM 1 × SIM (2FF)
    Ethernet 1 × 10/100/1000 Mbps RJ45
    Wi-Fi none – wired Ethernet only
    Inputs / outputs 2 configurable I/O (on 4-pin power connector)
    USB micro USB (virtual network interface)
    Antenna connectors 1 × SMA (LTE)
    Power supply 4-pin DC connector or passive PoE
    Power consumption < 5 W
    Processor ARM Cortex-A7, 1.2 GHz
    Memory 128 MB RAM
    Dimensions 74.5 × 25 × 64.4 mm
    Installation compact, into a cabinet or device housing
    Management RutOS (web interface), Teltonika RMS remote management
    VPN OpenVPN, IPsec, WireGuard and more

    Key functions

    • 4G LTE Cat 4 – up to 150 Mbps download, 3G/2G fallback
    • Inputs / outputs – door contact, alarm signal, relay control, SMS notifications
    • PoE power – one cable for data and power
    • VPN and firewall – secure remote access to site equipment
    • Teltonika RMS – monitoring and configuring many devices from one place

    Where is it used?

    • A single PLC or controller at a remote site
    • Electricity, water and heat meter reading
    • IP camera or NVR without fixed internet
    • Remote service by equipment manufacturers (integration into the product)
    • Solar inverter monitoring
    • Backup channel for one device

    Use by need

    Equipment manufacturer.
    A compact module integrated into the product for remote service.
    Automation integrator.
    A single PLC or controller online without a router or Wi-Fi.
    Energy engineer.
    Meter or inverter data to the cloud with minimal power consumption.

    Practical use

    If a solar inverter or PLC needs remote access, the Teltonika TRB140 is connected with an Ethernet cable directly to the device, the LTE antenna is taken outside the cabinet, and the device becomes reachable via VPN or RMS.

    Pros

    • 4G LTE Cat 4 up to 150 Mbps
    • Gigabit Ethernet
    • PoE power
    • RutOS and Teltonika RMS management
    • Equipment from a Lithuanian manufacturer, extensive documentation

    Cons / limitations

    • No 5G – the fastest connection requires a 5G model
    • No Wi-Fi – wired Ethernet for one device only
    • Single SIM – no backup operator

    Safety and installation notes

    • Installation in a cabinet or on a building should be carried out by a qualified electrician following electrical installation rules
    • Connect power only with the voltage switched off; check polarity and voltage range (see datasheet)
    • Seal outdoor antenna cables and earth antennas and masts – protection against lightning surges
    • Insert or replace the SIM card only with the power off
    • Do not install close to frequency converters and power cables without separation – interference degrades the connection
    • Change default passwords, update firmware, do not expose the management interface to the internet without VPN

    Quick selection guide

    4G LTE Cat 4
    up to 150 Mbps
    1 SIM
    1 × Gigabit
    1 × 10/100/1000 Mbps RJ45
    < 5 W
    Suitable when you need:
    • connecting a single device to the internet
    • a compact solution in a cabinet or product
    • low power consumption
    • remote service via VPN / RMS
    Check before use:
    • operator 4G coverage on site (best measured on location)
    • antenna needs – inside a cabinet or metal enclosure external antennas are required
    • supply voltage and connector type
    • the SIM data plan (M2M / IoT plans are cheaper for telemetry)
    Important reminder: the gateway has no Wi-Fi and is meant for one device – several devices will need a switch or a router with more ports.

    FAQ

    Does it work with any operator’s SIM?
    Yes – the device is unlocked and works with SIM cards (2FF format) from Baltic and other EU operators.
    Will it work without 4G?
    Yes – with a weak 4G signal it uses the 3G/2G network if the operator still supports it (3G networks are being switched off in the Baltics).
    Can an external antenna be connected?
    Yes – LTE antennas connect via SMA connectors, so external directional antennas can be used.
    How can I access the device remotely?
    Via VPN (OpenVPN, IPsec, WireGuard) or the Teltonika RMS cloud system.
    Where is it installed?
    On a DIN rail, wall or desk – depending on the model (see table).
    What SIM plan do I need?
    A small M2M plan is enough for telemetry; for video cameras and internet use an unlimited data plan.

    Industrial 4G LTE gateway | Cat 4 | 1 × Gigabit Ethernet | I/O | compact | Teltonika TRB140

    Teltonika TRB140 – industrial 4g lte gateway with 4G LTE Cat 4. Reliable connectivity for remote sites, automation and telemetry.

    Published: 2026-11-16 · Data verified against the manufacturer datasheet: 2026-11-16

    Illustrative image may have been created using AI. The appearance of the product may differ slightly from the image shown. Please refer to the technical specification.
  • Subscribtion to new arrivals

    privacy policy

    Information