LC1K contactor | 3P | 6A | 115VAC coil | 3NO auxiliary contacts | for electric motors and control circuits

LC1K Contactor – 3P, 6A, 115VAC Coil, 3NO Power Contacts, for Electric Motors and Control Circuits

The LC1K Contactor 3P 6A 115VAC 3NO is a compact electromagnetic contactor designed for switching electric motors, lighting, heating, ventilation, automation, and other electrical circuits on and off. The contactor features 3 poles, a 6A rated current, a 115VAC control coil, and 3 normally open power contacts.

• Motor control – for low-power motors, pumps, fans, or actuators.
• Automation panels – as an actuator controlled by a relay, controller, or pushbuttons.
• Lighting circuits – when lighting groups need to be switched on or off via a control circuit.
• Heating and ventilation systems – for controlling fans, heating elements, or other equipment based on an automation signal.
• Industrial equipment – for switching technological components, auxiliary mechanisms, and control circuits.

For instance, the contactor is installed in a control panel and used to start a small three-phase motor. The control circuit may include START/STOP buttons, a protective thermal relay, or an automation controller. Upon pressing the START button or receiving a control signal, 115VAC voltage is applied to the coil, the contactor engages, and starts the motor.

When the control signal is lost, protection triggers, or the STOP button is pressed, the contactor disengages and disconnects the load from the power circuit.

For Electricians: A convenient choice when assembling control panels, motor starting circuits, automation nodes, or control circuits for low-power loads.

For Automation Specialists: The contactor can be used as an actuator controlled by a relay, timer, programmable controller, or other automation equipment.

For Engineers/Designers: A suitable component when designing systems requiring three-pole power circuit switching and 115VAC control voltage.

For Maintenance Specialists: Can be used when replacing or upgrading existing contactors, provided the coil voltage, contact configuration, current, and mounting requirements match.

The contactor is an electrical circuit control device; therefore, before installation, it is essential to assess the load type, rated current, coil voltage, contact configuration, protection devices, and the specific control circuit.

• Installation must be performed by a qualified electrician in accordance with electrical safety regulations.
• Ensure power is disconnected before working and verify the circuit is de-energized.
• Coil voltage must match the control circuit – this contactor requires 115VAC control voltage.
• Do not exceed rated parameters – the load must match the contactor's permissible current and utilization category.
• Use protection in motor circuits – such as a circuit breaker, fuses, and a thermal relay if necessary.
• Verify circuit compatibility with the specific motor, equipment, controller, or automation system.

Quick Selection Guide

The LC1K 3P 6A 115VAC 3NO contactor is suitable when a compact contactor is needed to control low-power three-phase loads in a system utilizing 115VAC control voltage. It can be used in control systems for motors, fans, pumps, lighting, or other equipment.

Compact Contactor for Control Panels, Automation, and Low-Power Loads

The LC1K 3P 6A 115VAC 3NO contactor is a practical solution when reliable switching of three-phase loads via a 115VAC control circuit is required. It is suitable for controlling motors, fans, pumps, lighting, and other electrical equipment.

Due to its 3-pole design, 3NO contacts, 6A rated current, and compact LC1K format, this contactor can be used in control panels, automation systems, and maintenance tasks where a clear, reliable, and easily integrated electrical circuit control component is required.