Aluminium power cable | 4x120mm² | AXMK | Class 2 | 1m | Black

The cable has four aluminium conductors with a cross-section of 120mm² and is designed for electrical systems with a rated voltage of 600/1000V. XLPE insulation is suitable for operation at a maximum working temperature of up to 90°C, while the PVC outer sheath protects the internal cable construction against environmental influences.

The cable's black PVC outer sheath is resistant to UV radiation, allowing the cable to be used in outdoor electrical installations where it is exposed to sunlight and other environmental conditions.

XLPE material is used for the cable conductor insulation. It is suitable for power cables and allows the cable to operate at a maximum working temperature of up to 90°C, subject to the design and operating requirements of the specific installation.

• 4x120mm² aluminium conductors are suitable for higher-power fixed electrical power transmission lines.
• Aluminium conductors are lighter than copper conductors of the same cross-section.
• XLPE insulation is designed for operation at a maximum working temperature of up to 90°C.
• The black PVC outer sheath is resistant to UV radiation.
• Can be installed outdoors and underground.
• Suitable for dry, damp and wet rooms.
• Can be installed in cable ducts and conduits.
• Can be installed directly in concrete.

• Aluminium conductor: cable lugs, terminals and installation methods suitable for aluminium or Al/Cu connections must be used.
• Class 2 conductor: the cable is intended for fixed installation and is not designed for continuously moving or frequently flexed connections.
• Large cable cross-section: installation requires consideration of cable bending possibilities, entry dimensions and sufficient space in the electrical panel.
• Permissible current is not the same under all conditions: the actual cable load capacity depends on the installation method, temperature, grouping and other installation conditions.

At an industrial site, a fixed electrical supply line needs to be installed between the main distribution board and another electrical distribution point. Based on the expected load, line length, voltage drop and installation conditions, the designer determines that a 4x120mm² aluminium cable is suitable. Part of the cable is laid underground, while another section is routed through a cable duct. XLPE insulation and the PVC sheath allow the cable to be used under these conditions, while the UV-resistant black sheath is suitable for sections of the line installed outdoors.

The cable conductors are made of aluminium. The cable consists of four conductors with a cross-section of 120mm².

The rated voltage of the cable is 600/1000V.

Yes. The cable is suitable for underground installation.

Yes. The cable is suitable for outdoor installations, and its black outer sheath is resistant to UV radiation.

Yes. The cable can be used in dry, damp and wet rooms.

Yes. The cable is suitable for direct installation in concrete.

The specified maximum operating temperature of the cable is 90°C.

The conductor insulation is XLPE, while the cable outer sheath is PVC.

The expected load current, cable length, permissible voltage drop, installation method, ambient temperature, cable grouping, protective device parameters and short-circuit conditions must be considered. The 120mm² cross-section alone is not sufficient to determine whether the cable is suitable for a specific installation.

For connecting aluminium conductors, use only terminals, cable lugs and other connection equipment suitable for aluminium or Al/Cu connections. Cable cross-section, permissible continuous current, protective devices, voltage drop and installation method must be selected according to the specific electrical installation design and installation conditions. If electrical calculations have not been performed, the cable must not be selected solely on the basis of equipment power or rated current.