LoRa wireless temperature and humidity sensor | −40…+80 °C, 0–100 % RH | LoRa | 3.6 V battery | IP65 | Renke RS-WS-LORA-2-EX
Code: ES-RS-WS-LORA-2-EXPrice 199.65 € VAT incl.( 165.00 € VAT excl. )Wireless LoRa temperature and humidity sensor with IP65 housing and a replaceable 3.6 V lithium battery. Measures −40…+80 °C and 0–100 % RH and sends data every 5 min via a Renke LoRa gateway to the cloud – no cables.
-
LoRa wireless temperature and humidity sensor | −40…+80 °C, 0–100 % RH | LoRa | 3.6 V battery | IP65 | Renke RS-WS-LORA-2-EX
Renke RS-WS-LORA-2-EX is a wireless temperature and humidity sensor for sites where running a cable does not pay off. It measures −40…+80 °C and 0–100 % RH, runs on a 3.6 V lithium battery and has an IP65 housing. Data goes over LoRa radio to the manufacturer's gateway and on to a cloud platform.
Key point:
The main gain is cable-free installation: mount it, switch it on, and the point appears on the platform. With a 5-minute interval the battery lasts about 3 years. It suits warehouses, greenhouses and scattered buildings where an RS485 line would cost more than the sensor itself.Temperature
−40…+80 °C, ±0.5 °CHumidity
0–100 % RH, ±3 % RHBattery
3.6 V, ~3 years (every 5 min)Range
up to 3000 m (line of sight)Communication interfaces and integration
LoRa (manufacturer protocol) Wireless transmission to a Renke LoRa gateway; up to 3000 m in open terrain, indoors through 3–4 concrete walls. Cloud platform The gateway uploads data to the cloud: web monitoring, history and alarm notifications. LoRaWAN compatibility is not stated by the manufacturer. Operating principle
Mount the sensor on a wall or structure in the monitored zone, away from direct sun and heat sources. No cables are needed – the built-in battery supplies power.
The sensor periodically (every 5 min by default) measures temperature and relative humidity and transmits them over LoRa to the Renke gateway.
The gateway uploads data to the cloud platform – you see current values and history and get notified when limits are exceeded.
Why choose Renke RS-WS-LORA-2-EX?
It removes the most expensive part – cabling. One gateway serves several sensors, so the monitoring network can grow step by step.Technical specifications
Product type Wireless LoRa temperature and humidity sensor Manufacturer / model Renke (Shandong Renke Control Technology) RS-WS-LORA-2-EX Temperature measuring range −40…+80 °C Temperature accuracy ±0.5 °C (at 25 °C) Humidity measuring range 0–100 % RH Humidity accuracy ±3 % RH (at 60 % RH, 25 °C) Long-term stability ≤0.1 °C/year; ≤1 % RH/year Response time T ≤25 s, RH ≤8 s (air flow 1 m/s) Electronics operating environment −40…+60 °C, 0–80 % RH Power supply Built-in replaceable 3.6 V lithium battery Battery life ~3 years at 5-min interval (default configuration) Communication LoRa (manufacturer protocol) via Renke LoRa gateway Transmission range up to 3000 m line of sight; indoors through 3–4 concrete walls Ingress protection IP65 Key functions
- Temperature measurement – −40…+80 °C, ±0.5 °C, also for cold zones.
- Relative humidity measurement – 0–100 % RH, ±3 % RH.
- LoRa transmission – up to 3000 m outdoors, through several walls indoors.
- Battery power – ~3 years without cables or maintenance.
- Cloud monitoring – history and notifications via Renke gateway and platform.
How does it differ from similar products?
22719 Sentera ODTHM Wired outdoor IP65 sensor with Modbus RTU – directly to PLC/BMS, but needs a cable and power. 18621 SONOFF SNZB-02DR2 Zigbee sensor with LCD and VPD for indoor use – smart home, shorter range, not IP65. 14906 IMOU ZTM1 Zigbee household T/RH sensor for the IMOU ecosystem – indoor, not for outdoor or industrial sites. Where is it used?
- Warehouses and logistics centres
- Greenhouses and grow rooms
- Cold rooms and cool storage
- Grain and vegetable stores
- Monitoring scattered buildings and farms
- Plant rooms, boiler rooms, attics
- Construction sites and temporary facilities
- Archives and museum storage
Use by need
For beginners.
Mount the sensor, switch it on and pair it with the Renke gateway as per the manufacturer's manual – no cables needed.For experienced installers.
Test the link on site before mounting: metal structures and reinforced concrete shorten the range. Place the gateway as high as possible.For engineers / designers.
Plan the number of gateways and the frequency band (check the EU-approved version), data interval and battery replacement schedule.Practical application
A farm has three separate stores 300–800 m from the main building. A wired RS485 network would require digging. RS-WS-LORA-2-EX sensors were mounted in each store, with one Renke gateway in the main building. Temperature and humidity are visible on the platform, and a notification arrives when a limit is exceeded.Pros / advantages
- Installation without cables or power lines
- Battery up to ~3 years at a 5-min interval
- Wide range: −40…+80 °C, 0–100 % RH
- IP65 housing – suitable outdoors
- Range up to 3000 m in open terrain
- Low drift: ≤0.1 °C and ≤1 % RH per year
Cons / limitations
- Requires a Renke LoRa gateway – LoRaWAN compatibility not stated by the manufacturer
- No wired output for PLC/BMS – choose 22719 Sentera ODTHM (Modbus RTU) for that
- Electronics operating environment up to +60 °C and 0–80 % RH – not for hot zones
- No display – values are visible only on the platform
- Shorter intervals reduce battery life
Safety and installation notes
- Mount away from direct sun, heaters and ventilation outlets – otherwise readings are distorted.
- When replacing the battery use only the 3.6 V lithium cell type specified by the manufacturer and observe polarity.
- Do not dispose of used lithium batteries with household waste – take them to a collection point.
- Do not install in explosive atmospheres – the sensor is not designed for this.
- The gateway's 230 V mains connection must be made by a qualified electrician.
Quick selection guide
−40…+80 °C0–100 % RHLoRa up to 3000 mIP65, battery ~3 yearsSuitable when you need:- monitor remote buildings without cables
- measure in cold or humid rooms
- expand monitoring gradually via one gateway
- receive notifications when limits are exceeded
Check before choosing:- whether you have or will buy a Renke LoRa gateway
- the radio frequency band – is it the EU-approved version
- whether a wired Modbus output to PLC/BMS is required
- ambient temperature at the sensor location (electronics up to +60 °C)
Important reminder: ⚠ According to the manufacturer this is not a LoRaWAN network device – without a Renke LoRa gateway you will not see any data. The sensor only measures and reports; it does not control ventilation or heating.☝ Elsprendimai.eu recommends:- Sentera ODTHM – If you need a wired Modbus RTU sensor outdoors – IP65, straight to a PLC or BMS.
- SONOFF SNZB-02DR2 – For indoor use and smart homes – Zigbee sensor with display and VPD value.
- Temperature and humidity sensor with LCD IMOU ZTM1 – Household Zigbee T/RH sensor for the IMOU ecosystem.
- Temperature and humidity sensor selection guide – Group selection guide: how to choose a T/RH sensor by communication, power and IP rating.
FAQ
Does the sensor work with a LoRaWAN network (TTN, Helium)?
The manufacturer states its own LoRa protocol; LoRaWAN compatibility is not stated. Plan for a Renke LoRa gateway.How long does the battery last?
About 3 years when data is sent every 5 min (default configuration). Shorter intervals reduce this.Is the battery replaceable?
Yes, the built-in 3.6 V lithium battery is replaceable.What is the real radio range?
Up to 3000 m line of sight. Indoors the signal passes through 3–4 concrete walls; metal shortens the range.Can it be used outdoors?
Yes, the housing is IP65. Protect it from direct sun, which distorts temperature readings.Can the sensor control a fan?
No. It only measures and sends data. Control requires a controller or hygrostat.Sources: Renke product page (RS-WS-LORA-2-*-T), distributor epower listing. Checked 2026-10-19.
Renke RS-WS-LORA-2-EX – LoRa T/RH sensor IP65
Wireless LoRa temperature and humidity sensor: −40…+80 °C, 0–100 % RH, IP65, 3.6 V battery up to ~3 years. Data travels via a Renke LoRa gateway to a cloud platform.
Published: 2026-10-19 · Data verified against the manufacturer's datasheet: 2026-10-19
Illustrative image may have been created using AI. The appearance of the product may differ slightly from the image shown. Please refer to the technical specification.This product is marked with the CE label, which confirms that it complies with all applicable European Union directives and regulations. CE marking is not just a formality – it is an important indicator of quality and safety, ensuring that the product has been properly assessed, tested, and can be safely used throughout the EU market.
CE certification means that the product has been evaluated according to the main criteria:
Safety requirements – ensures that the product does not pose a risk to the user or the environment
Electromagnetic compatibility (EMC) – the device does not interfere with other equipment and is resistant to external disturbances
Environmental standards – complies with current ecological and material usage requirements
Operational reliability – the product is suitable for long-term use according to its intended purposeCE marking allows this product to:
be legally supplied and used in all European Union countries
ensure a high level of quality and safety
be used in residential, commercial, and industrial environmentsThe CE mark is a declaration of the manufacturer’s responsibility, confirming that the product complies with all applicable standards and has been assessed according to EU legislation.
What does this mean for you as a buyer?
Safe use in everyday activities
Reliable performance and reduced risk of failure
Compliance with EU standards and requirements
Suitability for professional solutions
Love it? Share your thoughts in a review!Write Review Alternative products
IP surveillance camera | Turret | 4 MP | 2.8 mm | IR 30 m | WDR 120 dB | PoE | IP66 | Hikvision DS-2CD2345FWD-ICode: DS-2CD2345FWD-IHikvision DS-2CD2345FWD-I is a 4 MP (2688 × 1520) turret camera with a 1/2.5" sensor, 120 dB WDR and IR up to 30 m. Line-crossing, intrusion and unattended-object detection, H.265+, PoE 802.3af, microSD up to 128 GB, IP66.
Price 137.00 € VAT incl.( 113.22 € VAT excl. )












