Aluminium power cable | 5×10 mm² | AXMK | 1 m | black

Aluminium power cable AXMK – 5×10 mm², 0.6/1 kV, XLPE, black, 1 m

AXMK 5×10 mm² aluminium power cableis intended for fixed electrical power supply and distribution lines. The cable consists of5 aluminium conductors, each with a cross-section of 10 mm², XLPE core insulation and a black UV-resistant PVC outer sheath.

The cable can be usedindoors, outdoors, in cable ducts, conduits and underground, provided that the installation location is not subject to high mechanical tensile loads or a high risk of mechanical damage. Rated voltage –0.6/1 kV, and the maximum continuous conductor operating temperature is up to+90 °C.

• Conductors:aluminium.
• Number of cores:5.
• Cross-section of one core:10 mm².
• Core insulation:XLPE – cross-linked polyethylene.
• Outer sheath:PVC.
• Sheath colour:black.
• UV resistance:yes.

• In dry indoor areas.
• In damp and wet areas, when installed in accordance with applicable requirements.
• Outdoors.
• In cable ducts and trays.
• In installation conduits.
• Underground.

For a house or outbuilding:may be used for a service connection or a separate power supply line if the 5×10 mm² aluminium cross-section complies with the project calculations.

For electricians:intended for fixed low-voltage cable routes where a 5-core 0.6/1 kV aluminium power cable is required.

For industrial applications:may be used for power distribution between switchboards, equipment zones or other electrical distribution points.

For designers:cable selection must take into account the permissible continuous current, voltage drop, short-circuit conditions, protective-device parameters, route length, ambient temperature and installation method.

1. Select the cable cross-section by calculation.
2. Plan the cable route.
3. Observe the minimum bending radius.
4. Do not install the cable at excessively low temperatureswithout measures permitted by the manufacturer.
5. Use terminals and lugs suitable for aluminium conductors.
6. Observe the tightening torque specified by the manufacturer of the connecting equipment.
7. After installation, carry out the required electrical measurements.

Quick selection guide

Choose AXMK 5×10 mm² cablewhen the project requires a 5-core 0.6/1 kV aluminium power cable for a fixed electrical distribution line and electrical calculations confirm that a 10 mm² aluminium conductor cross-section is sufficient.

5×10 mm² aluminium conductors, XLPE insulation and 0.6/1 kV rated voltage

AXMK 5×10 mm² is a five-core aluminium power cable intended for fixed low-voltage power supply and distribution lines. The XLPE core insulation is designed for a continuous conductor operating temperature of up to +90 °C.

The black UV-resistant PVC sheath allows the cable to be used in indoor and outdoor installations, cable ducts, conduits and underground routes.

The product is soldby the metre– the quantity ordered corresponds to the required cable length in metres.